Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| articles:changing_manual_transmission_fluid_on_a_190e [2020/11/09 08:40] – [Choosing a fluid] john5788 | articles:changing_manual_transmission_fluid_on_a_190e [2020/11/10 08:58] (current) – [Procedure] john5788 | ||
|---|---|---|---|
| Line 31: | Line 31: | ||
| < | < | ||
| {{ transmissions: | {{ transmissions: | ||
| - | < | + | < |
| </ | </ | ||
| </ | </ | ||
| Line 37: | Line 37: | ||
| < | < | ||
| {{ articles: | {{ articles: | ||
| - | < | + | < |
| </ | </ | ||
| </ | </ | ||
| </ | </ | ||
| + | < | ||
| + | <col sm=" | ||
| + | <panel type=" | ||
| + | ^ Transmission Type ^^ Capacity (L) ^ | ||
| + | | 4-speed transmission | 716.0 | 1.6 | | ||
| + | | ::: | 716.21 | 1.3 | | ||
| + | | 5-speed transmission | 717.40 | 1.6 | | ||
| + | | ::: | 717.41 | 1.5 | | ||
| + | | ::: | 717.41 | 1.5 | | ||
| + | | ::: | 717.43 | 1.5 | | ||
| + | | ::: | 717.45 | 1.7 | | ||
| + | </ | ||
| + | </ | ||
| + | </ | ||
| + | ===== Tools needed ===== | ||
| + | < | ||
| + | <col sm=" | ||
| + | * Method to lift vehicle | ||
| + | * Drain pan | ||
| + | * Hazet oil service wrench, part number 117 589 02 07 00. 14mm hex, 13mm box end. Or a 14mm hex tool short enough to fit in the transmission tunnel | ||
| + | * Fluid transfer pump | ||
| + | </ | ||
| + | <col sm=" | ||
| + | < | ||
| + | {{ articles: | ||
| + | < | ||
| + | </ | ||
| + | </ | ||
| + | <col sm=" | ||
| + | < | ||
| + | {{ articles: | ||
| + | < | ||
| + | </ | ||
| + | </ | ||
| + | </ | ||
| + | |||
| + | ===== Procedure ===== | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | < | ||
| + | <col sm=" | ||
| + | - Lift vehicle such that vehicle is level in the air | ||
| + | - Remove oil filler plug first, pay attention as to not lose the metal seal ring. | ||
| + | - Perform this item first to make sure there is a method for refilling the transmission with fluid | ||
| + | - Remove oil drain plug, pay attention as to not lose the metal seal ring | ||
| + | - Once fluid is completely drained, clean drain plug, and reinstall with max torque of 60 Nm | ||
| + | - Using the fluid transfer pump, fill the transmission fluid until it overflows from the filler hole | ||
| + | - Reinstall oil filler plug | ||
| + | - Lower the vehicle, check for leaks | ||
| + | </ | ||
| + | <col sm=" | ||
| + | < | ||
| + | <col sm=" | ||
| + | < | ||
| + | {{ articles: | ||
| + | < | ||
| + | </ | ||
| + | </ | ||
| + | <col sm=" | ||
| + | < | ||
| + | {{ articles: | ||
| + | < | ||
| + | </ | ||
| + | </ | ||
| + | <col sm=" | ||
| + | < | ||
| + | {{ articles: | ||
| + | < | ||
| + | </ | ||
| + | </ | ||
| + | </ | ||
| + | </ | ||
| + | </ | ||