Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revisionBoth sides next revision | ||
| articles:m104_head_gasket_replacement [2024/03/12 07:16] – john5788 | articles:m104_head_gasket_replacement [2024/03/13 06:18] – john5788 | ||
|---|---|---|---|
| Line 67: | Line 67: | ||
| - Reach down between gap and disconnect knock sensor below cylinder 5 | - Reach down between gap and disconnect knock sensor below cylinder 5 | ||
| - Remove air intake manifold | - Remove air intake manifold | ||
| + | |||
| + | ===== Remove Cylinder Head ===== | ||
| + | - Remove EGR support bracket | ||
| + | - Loosen hose clamp on coolant hose at back of cylinder head and pull off hose | ||
| + | - Remove cylinder head bolts, starting with bolt #14 on the outside working towards the center | ||
| + | - Lift cylinder head off engine block. Cylinder head weight approximately 80 lb. | ||