This is an old revision of the document!
Replacing 190E Steering Gearbox
This article is a reference for replacing the steering gearbox on a 190E and may be applicable to similar models. Remanufactured steering gearboxes may be purchased from C & M Hydraulics based in Las Vegas, Nevada.
Time | 2 hours |
---|---|
Cost | |
Difficulty | |
Parts Required | Power steering fluid - 1 46 0001 Power steering filter - 000 466 2104 Steering coupler - 123 460 0210 Renew locking hex nuts for tie rod ends - N913002010010 |
Applicable models | All 190Es with left hand drive |
Special Tools
Balljoint separator - Used for removing the left tie rod and center drag link
Gear puller - Removing pitman arm from steering gearbox output shaft
Suction gun - Used to remove old power steering fluid
Snap ring plier - Remove snap ring from pitman arm shaft
Power Steering Fluid
Procedure
Preparation
- Lift front end of vehicle in the air
Siphon / Drain Old Fluid
- Remove power steering fluid reservoir cap
- Remove filter
- Filter is held in place by a 10mm nut under spring tension. Caution when removing this 10mm nut as it may spring out once unthreaded
- Pull old filter out with pliers
- Use a suction gun to remove old fluid.
- Rotate steering wheel left and right to pump more fluid back into the reservoir. Remove as much as possible.