Differences

This shows you the differences between two versions of the page.

--- transmissions:722.3 [2022/11/14 03:05] – john5788
+++ transmissions:722.3 [2022/11/14 03:29] (current) – [Main Valve Body] john5788
@@ Line 472: / Line 472: @@
 === Reassembly ===
+<grid>
+<col sm="6">
+</col>
+<col sm="6">
+<grid>
+<col sm="6">
+<thumbnail>
+{{ transmissions:7223_upper_valve_body_check_balls.jpg?300 }}
+<caption>Upper valve body check balls</caption>
+</thumbnail>
+</col>
+<col sm="6">
+<thumbnail>
+{{ transmissions:7223_upper_valve_body_springs_valves.jpg?300 }}
+<caption>Upper valve body springs and valves</caption>
+</thumbnail>
+</col>
+<col sm="6">
+<thumbnail>
+{{ transmissions:7223_lower_valve_body_valves.jpg?300 }}
+<caption>Lower valve body valves</caption>
+</thumbnail>
+</col>
+</grid>
+</col>
+</grid>
 === Installation ===
@@ Line 497: / Line 526: @@
 <grid>
 <col sm="6">
-  - Remove shift valve housing
+  - Remove main valve body housing
   - Remove bracket and detent leaf spring, 1x 10mm hex bolt
   - Remove bolts securing lower cover to transmission case, 9x 10mm hex bolts
-  - Pull lower cover along with large intermediate plate away from transmission
+  - Pull secondary valve body along with large intermediate plate away from transmission
   - Oil deflector piece may fall out from front side of transmission after intermediate plate is removed
 </col>
@@ Line 507: / Line 536: @@
 <thumbnail>
 {{ transmissions:7223lowercoverintermediateplate.jpg?300 }}
-<caption>Lower cover and intermediate plate</caption>
+<caption>Secondary valve body and intermediate plate</caption>
 </thumbnail>
 </col>
@@ Line 531: / Line 560: @@
 <thumbnail>
 {{ transmissions:7223lowercover.jpg?300 }}
-<caption>Lower cover</caption>
+<caption>Secondary Valve Body</caption>
 </thumbnail>
 </col>
@@ Line 537: / Line 566: @@
 <thumbnail>
 {{ transmissions:7223lowercovergasketaligned.jpg?300 }}
-<caption>Lower cover gasket aligned</caption>
+<caption>Secondary valve body gasket aligned</caption>
 </thumbnail>
 </col>
@@ Line 544: / Line 573: @@
 {{ transmissions:7223intermediateplateandgasketinstalled.jpg?300 }}
 <caption>Intermediate plate and gasket installed</caption>
+</thumbnail>
+</col>
+<col sm="6">
+<thumbnail>
+{{ transmissions:7223_reverse_lockout.jpg?300 }}
+<caption>Removing reverse lockout plunger</caption>
 </thumbnail>
 </col>
@@ Line 556: / Line 591: @@
   - Clean transmission case of any pieces of the old gasket
   - Install oil deflector if it was removed
-  - Mount lower cover with intermediate plate against transmission case while aligning oil pipe
+  - Mount secondary valve body with intermediate plate against transmission case while aligning oil pipe
   - Secure bolts holding lower cover to transmission case, 9x 10mm hex bolts, torque to 8 Nm
   - Mount detent leaf spring and bracket