Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| articles:400e_brake_caliper_rebuild [2021/12/30 08:13] – [Reassemble] john5788 | articles:400e_brake_caliper_rebuild [2021/12/30 08:15] – [Reassemble] john5788 | ||
|---|---|---|---|
| Line 214: | Line 214: | ||
| <image shape=" | <image shape=" | ||
| + | |||
| + | \\ | ||
| < | < | ||
| Line 222: | Line 224: | ||
| - Install dust cap on the piston | - Install dust cap on the piston | ||
| - Lubricate piston and cylinder with brake assembly fluid and reinsert piston into cylinder bore. | - Lubricate piston and cylinder with brake assembly fluid and reinsert piston into cylinder bore. | ||
| + | - Check orientation of piston with heat shield before inserting piston into cylinder bore | ||
| - Use a long screw driver or a long 1/4" extension across the top of the piston to help drive the piston down | - Use a long screw driver or a long 1/4" extension across the top of the piston to help drive the piston down | ||
| - Seal dust cap along the collar of the cylinder bore | - Seal dust cap along the collar of the cylinder bore | ||
| - Install new metal heat shields on top of the pistons | - Install new metal heat shields on top of the pistons | ||
| + | - Use caliper piston compressor if necessary | ||
| - Install new brake bleeder valves | - Install new brake bleeder valves | ||
| </ | </ | ||