Differences

This shows you the differences between two versions of the page.

--- articles:cis-e_fuel_adjustment [2021/09/07 05:44] – [Adjusting EHA Valve] john5788
+++ articles:cis-e_fuel_adjustment [2021/10/02 02:10] – [Adjusting Fuel Distributor Screw] john5788
@@ Line 71: / Line 71: @@
 ==== Adjusting EHA Valve ====
+<grid>
+<col sm="6">
   - Remove EHA valve from fuel distributor
     - Unplug wire connector
-    - Remove 2 screws holding EHA valve to fuel distributor while covering the EHA valve with a rag to catch fuel that will squirt in your face
+    - Remove 2 screws holding EHA valve to fuel distributor while covering the EHA valve with a rag to catch fuel that will squirt at your face
     - Pull EHA valve off fuel distributor, noting the 2 green rubber sealing rings.
   - Remove the screw cover with a flathead screw driver
@@ Line 80: / Line 84: @@
     - Turn counter-clockwise to **lean the fuel mixture**. This **increases the duty cycle** or **decreases the voltage**, depending on whatever method you are using.
   - Reinstall EHA valve
+</col>
+<col sm="6">
+<grid>
+<col sm="6">
+<thumbnail>
+{{ articles:eha_valve_screws.png?300 }}
+<caption>EHA valve screws</caption>
+</thumbnail>
+</col>
+<col sm="6">
+<thumbnail>
+{{ articles:eha_valve_seals.png?300 }}
+<caption>EHA valve seals</caption>
+</thumbnail>
+</col>
+</grid>
+</col>
+</grid>
 ==== Adjusting Fuel Distributor Screw ====
-If there is a steel plug  present, it needs to be drilled out first.
+If there is a steel plug  present, it needs to be drilled out first. Engine must be idling for this adjustment.
 <grid>